Publicité
Les langues disponibles
Les langues disponibles
This will not affect the elevator, but it will require you turn several times the handle clockwise before
you actually see an elevation again.
D
u
r
i
n
g
t
r
a
n
s
p
o
r
t
D
u
r
i
n
g
t
r
a
n
s
p
o
r
t
Remove the load and the trussing support device. Fold the extension module if any with safety pin (K)
Push down if required the upper section until spring lock (S) comes into locking position.
PRO3500-4000-4500 serie
Unlock the sliding foot support and slide it up until it locks itself in position (A) and tighten locking
screw (B).
Unlock rear foot (D) fold it back and lock it into position ( C).
PRO5000-5200serie
Unlock each legs (N), and position it in it's storage support (Q) jusqu'à son verrouillage en position.
Pull the lifter with the handle (M) as it gently rolls on wheels.
.
M
a
i
n
t
e
n
a
n
c
e
M
a
i
n
t
e
n
a
n
c
e
Goliath Studio Pro range elevator does not require maintenance. It has been greased at factory and is
designed to operate at nominal load for 2 years with one complete cycle (up and down)once a day.
In case of intensive use, it is necessary to check if a potential wear of the rack is visible and if
necessary to grease accordingly the rack.
It is strictly forbidden to open the elevator mechanism and grease it.
P
r
o
d
u
c
t
c
e
r
t
i
f
i
c
a
t
i
P
r
o
d
u
c
t
c
e
r
t
i
f
i
c
a
t
Every lifting equipment must be inspected at least once a year and pass a load test in order to be
certified for the following 12 month.
This certification must be performed by an authorized inspector.
Goliath Studio offers various certification and maintenance contract and can repair it should it be
damaged or beyond warranty (contracted work based on quote).
You can also contact Goliath studio after sales service to perform such test.
Any modification or alteration of the product will automatically cancel the warranty and withdraw
Goliath studio responsibility.
C
e
r
t
i
f
i
c
a
t
i
o
n
s
C
e
r
t
i
f
i
c
a
t
i
o
n
s
Our product conforms to European standards and recommendation.
Directives 2006/42/CE, Standard EN12100-2010, EN13157+A1, BGVC1 and BGG 912 rules.
And benefit from the CE marking.
However our internal certification process test and manufacturing standards are of a higher level of
requirement than the above mentioned standards which enables us to provide a 2 year warranty for all
PRO serie lifters.
W
a
r
r
a
n
t
y
W
a
r
r
a
n
t
y
Goliath studio Pro elevator has a 2 years warranty
The warranty includes the lifting mechanism, the safety devises and the telescopic mechanism.
The warranty starts from the factory shipping date (date of invoice or delivery note)
This warranty is valid as long as the elevator is used in full conformity with the conditions of use and
safety specified in this manual and within the limit of 1 complete cycle of operation per day (400 days
within 2 years) and providing yearly test certification is completed par an authorised professional.
The following damages are not covered by the warranty:
Shock, scratches, and alteration of the product or its labelling.
o
n
i
o
n
8
Publicité
