How To Wire Your Ceiling Fan - Luminance Brands kathy ireland HOME PREMIUM SELECT ECO CF4802AP00 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. How to Wire Your Ceiling Fan

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
5.1
Position the Supply Wires to the left side of the Outlet
Box (Figure 18); position the Fan Wires to the right
side .
Partially insert the Remote Control Receiver (flat side
up) until one end rests on the Hanger Ball as shown in
Figure 18 .
CAUTION
!
To reduce the risk of electrical shock, disconnect the
electrical supply circuit before installing the fan or
receiver.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
5.2
Connect the Hanger Ball Green Grounding Wire,
the Hanger Bracket Green Grounding Wire, and
the Receiver Green Grounding Wire to the Supply
Grounding Conductor (this may be a bare wire or wire
with green colored insulation) .
Securely connect Wires with a 12 ga . Wire Connector
(supplied in parts bag) (Figure 19) .
NOTE: Make all Wiring Connections using
Wire Connectors (supplied). Make sure that all
Connections are tight, including Ground, and that
no bare wire is visible at the Wire Connectors,
except for the Ground Wire.
Figure 18
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product
by Luminance Brands. Substitution of parts or
accessories not designated for use with this product
by Luminance Brands could result in personal injury
or property damage.
RECEIVER GREEN
GROUNDING WIRE
HANGER BRACKET
GREEN GROUNDING
WIRE
SUPPLY
GROUNDING
CONDUCTOR
HANGER BALL
GREEN GROUNDING
WIRE
Figure 19
13
REMOTE
CONTROL
RECEIVER
HANGER
BALL
WARNING
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: CF4802 and CF4502

Publicité

Table des Matières
loading

Table des Matières