Hitachi CG36DL (L) Mode D'emploi page 20

English
(4) Release about 5-15/16" (150 mm) of the nylon cord
from both ends, fold the middle part and attach to
the hook on the spool. Next, wind the cord on the
spool in the direction shown by the arrow, being
careful not to crisscross it (Fig. 24, 25).
Nylon line
5-15/16"
(150 mm)
Fig. 24
(5) Leave about 3-15/16" – 5-15/16" (100 mm – 150 mm)
nylon cord unwound, hook and secure the line in
the stopper. (Fig. 26)
Secure in the
stopper
NOTE:
Do not cross the nylon line when securing the line
in the stopper. (Fig. 27)
(6) Align the position of the stopper and eyelet line
guide, and then insert the button through the case.
Release the line from the stopper while holding
the reel lightly, and then string the line through
the eyelet line guide. (Fig. 28)
20
Groove of the reel
Folded center of
Reel
nylon cord
Fig. 25
Fig. 26
Fig. 27
Nylon line
Eyelet line guide
(7) Press and snap the tabs of the case in the locking
holes of the cover. (Fig. 29)
WARNING
Check to make sure the tabs are firmly snapped
into the locking holes.
Operating the gardening appliance while the parts
are not firmly snapped together may results in
accidents or injury from flying part.
(8) Pull the line taught so there is no slack, and then cut
the line to an extended length of 3-17/32"– 4-5/16"
(90 mm – 110 mm) with scissors. (Fig. 30)
Stopper
Reel
While holding
the reel
String the
line
through
the eyelet
line guide
Fig. 28
Locking holes of
cover (2 holes)
Tabs of case
(2 tabs)
Fig. 29