Hitachi CG36DL (L) Mode D'emploi page 19

Cover
Screw
CAUTION
Install the nylon head properly and securely as
instructed in the handling instructions.
If not attached properly or securely, it may come
off and cause injury.
The mounting nut of nylon head is left-hand-
threaded. Turn
counterclockwise to tighten.
3. Adjustment of line length
Rotate and tap the nylon head on the ground.
Nylon line is drawn out abt, 1-3/16"(30 mm) by one
tapping. (Fig. 20)
Nylon line
Tap
Also, you can extend nylon line with hands. This
time the motor must be completely stopped.
Confirm the line extends in 1-3/16" (30 mm) increments
by "tapping" and "releasing" the bottom button while
pulling the line ends of the nylon head. (Fig. 21)
Appropriate length of nylon line
The appropriate length of the line when the gardening
appliance is in use is 3-17/32"– 4-5/16" (90 – 110 mm).
Extend the line to the appropriate length.
Nylon head
Threaded fastener
Hole
Allen wrench 4 mm
Fig. 19
clockwise to loosen/
Nylon head
Fig. 20
Tap/release
4. Nylon line replacement
(1) Prepare 13.12 ft. (4 m) of genuine nylon line in
Fig. 16. (Code No.335235)
If the cross section is circular, 0.055 in. (ø1.4 mm)
of line can be used.
(2) Press the opposing tabs, and then remove the
cover from the case. (Fig. 22)
Cover
(3) Remove the reel from the case. (Fig. 23)
If there is nylon line remaining, hook the line in
the groves, and then remove the reel.
If the nylon line does not extend when there is
enough nylon line remaining, or when replacing
the nylon line (Code No. 335235), wind the nylon
line using the following procedure.
Groove
English
Extends in 1-3/16"
(30 mm) increments
Appropriate
length 3-17/
32"– 4-5/16"
(90 – 110 mm)
Fig. 21
Tab
Press tabs
(2 areas)
Case
Fig. 22
Reel
Fig. 23
19