Assembly - Iseki BBH130 Notice D'utilisation

running. Allow engine to cool before refueling. Do not
smoke while refuelling.
c) Never refuel the machine indoors.
d) Never store the machine or fuel container inside
where there is an open flame such as a water heater
e) Always replace & securely tighten the fuel cap after
refilling.
f) If fuel is spilled, do not attempt to start the engine,
but move the machine away from the area of spillage
before starting.
5. Check the amount of oil and fuel before operation
6. It is recommended to do a run test to make sure connecting
parts are firm. (For detailed information please refer to the
engine instruction manual.)
7. After testing the machine it is recommended to gradually
increase the loading.
8. If the machine makes abnormal vibration or unusual noises,
immediately turn the machine off and get it checked by an
authorized person.
9. If there is many uncut materials it shows that blades may be
need to be sharpened or intervals may need to be adjusted.
Take the machine to an authorised dealer to sharpen/install
new blades.
10. If the cutting mechanism strikes any foreign objects or if the
machine should start making any unusual noise or vibration,
immediately shut off the engine and allow the machine to
stop. Disconnect the spark plug and take the following steps:
1) Inspect for damage
2) Replace or repair any damaged parts
3) Check for and tighten any loose parts.

Assembly

All bolts, washers and nuts have been fixed at its original place
inside the packaging.
This machine is large in volume, heavy in weight and it has many
switches. When assembling the machine seek guidance and
assistance from an authorised dealer or a person who has a
considerable knowledge of this machine to ensure safety
Warning
In the process of installation, do not place hands or any
other body parts within blade housing. Do not touch the
blades with your hands or any other body parts.
1) Frame Installation
Original version
546336.B.9
Number
10
1.1 Assemble the Wheel Axle (4) on the Base frame (8) using Bolt (5)
with Nut and washer.
1.2 Fix the wheels (1) as shown in the picture on wheel axle by
using bolt and washer (2).
1.3 Attach Front shock pads (6) on the Base frame using Bolt (3).
2) Handle and Hand Wheel Installation
11
7
No.
11
12
13
14
15
16
17
18
19
Description
1 Wheel
2 Bolt
3 Bolt
4 Wheel Axle
5 Bolt
6 Front Shock pad
7 Belt Cover
8 Base Frame
9 Engine
Drum
Warning
In the process of installation, do not place hands or any
other body parts within blade housing. Do not touch the
blades with your hands or any other body parts.
11
Description No.
Bolt 20
Inlet Chute 21
Outlet Chute 22
Rear Shock Pad 23
Blade Housing 24
Bolt 25
Locking Pin 26
Safety Bar 27
Bolt
Description
Sleeve
Bolt
Spring
Interlocking Switch
Knob
Handle
Hand Wheel
Bolt
7