Yamaha YID-W10 Mode D'emploi page 9

Transmitter
LED
Green: lights up No sound.
Red: Off
The volume of
iPod/iPhone
does not change
when you
operate the
volume of your
Yamaha
component.
Sound is output
suddenly despite
your iPod/
iPhone is not
connected to the
transmitter.
Ring tone is
output from your
Yamaha
component when
your iPhone
receives an
incoming call.
The battery is
not charged.
The Wi-Fi
communication
is unstable when
you are using
YID-W10.
Problem
The volume is set to the
minimum.
Your Yamaha component is
turned off.
The input source of your
Yamaha component is not
set properly.
Earphones or other device
are connected to your iPod/
iPhone.
Wireless communications
are established between this
unit's transmitter and
multiple "AirWired" devices
simultaneously.
Wireless communication is
established between the
receiver and another
"AirWired" device.
Ring tone is output from
your Yamaha component
when your iPhone receives
an incoming call.
The battery charge function
is not activated on your
Yamaha component.
The signal from YID-W10
interferes with Wi-Fi
communication.
Cause
Set the volume properly.
Turn on your Yamaha
component.
Set the input source
properly.
Disconnect earphones or
other device.
Set the group IDs of the
other "AirWired" devices to
the different value.
Set the group ID of another
"AirWired" device to the
different value.
If you do not want your
Yamaha component to
output ring tone, set your
iPhone to the silent mode.
Change the setting of your
Yamaha component
referring to its owner's
manual.
Disconnect your iPod/
iPhone from the transmitter,
and then reconnect firmly
after a while.
If this situation occurs
frequently, move YID-W10
away from the Wi-Fi
components.
Remedy
7
En