dirna Bergstrom bycool green line SPLIT Mode D'emploi page 16

SPLIT
EN
COMPRESSOR MOTOR
1 Remove the compressor motor protection frame,
place in the position required for installation,
mark and make boreholes and secure with the
screws supplied.
1
2 Take the 5/8 piping through to the compressor,
cut at the most appropriate measurement,
secure the M180 coupling and connect to the
compressor motor. (see photo point 4).
3
Cut the 5/8 piping and secure the load connection
point in the required place.
1
1
16
Air conditioning for vehicles