Internal Blower; Remote Blower - Wolf ICBDD36 Guide D'installation

INSTALLATION
Installation

INTERNAL BLOWER

To mount the internal blower on the front or rear of the
downdraft:
Rotate the blower box so the round discharge
152 mm
1
is properly located, then disconnect the cable from the
downdraft receptacle and connect it to the blower recep-
tacle. Refer to the illustrations below.
Once the blower connection is made and the discharge
2
properly located, secure the blower to the downdraft
using the four screws provided.
DISCHARGE DOWNDRAFT BLOWER
RECEPTACLE RECEPTACLE
Left, right or bottom discharge. Blower connection.
To mount the internal blower on the front of the downdraft
but discharge from the rear:
Remove the blower from the blower box.
1
Mount the blower motor to the downdraft using the two
2
screws provided.
Remove the blower plug from the downdraft receptacle
3
and insert it into the blower receptacle. Refer to the illus-
tration below.
Once the plug is installed and the blower secure, install
4
the blower box to the downdraft using the four screws
provided.
Remove the 152 mm collar from the blower box and
5
solid cover from the rear of the downdraft, then reinstall
the 152 mm collar on the rear and solid cover on the
blower box. Refer to the illustration below.
DOWNDRAFT
COVER
RECEPTACLE
BLOWER
RECEPTACLE
Blower mounting. Install cover.

REMOTE BLOWER

Insert the electrical supply from the remote blower
1
through the opening on the downdraft and secure using
an approved cord strain relief.
Connect hot to brown, neutral to blue and ground to
2
green. Refer to the illustration below.
HOT
GROUND
POWER CORD
RECEPTACLE
WIRING
COVER
Wiring location. Remote blower wiring.
COLLAR
COUNTERTOP MOUNTING
Place the downdraft in the opening, then secure the bottom
brackets to the cabinet base using the wood screws pro-
vided. Once the brackets are secure, tighten the existing
lower bracket screws. Refer to the illustration below.
Secure the top mounting brackets to the countertop using
the wood screws provided. For solid surface countertops,
silicone may be used but is not provided.
Once the top is secure, install the undercounter brackets
NEUTRAL
using the screws provided then install the side covers. Refer
to the illustration below.
MOUNTING
SCREW
BLUE
BROWN
Countertop mounting.
COVER
Cover installation.
|
wolfappliance.com 5