Wolf ICBDD36 Guide D'installation page 4

SPECIFICATIONS
Downdraft
INSTALLATION WITH SEALED BURNER RANGETOP
68 mm
483 mm
PLATFORM DEPTH
540
mm
210
mm*
SIDE VIEW SIDE VIEW
*152 mm back from countertop cut-out when internal blower is rear mounted.
NOTE: Internal blower 152 mm round, side, rear or bottom discharge. Remote blower 254 mm round, rear discharge.
Centerline indicates center of downdraft cut-out.
CUT-OUT WIDTH
MODEL
ICBDD30
|
4 English
W
DOWNDRAFT
CUT-OUT WIDTH
E
210 mm*
RANGETOP OPENING
TOP VIEW
540 mm 594 mm
E
FRONT VIEW FRONT VIEW
W
699 mm
INSTALLATION
Installation
DOWNDRAFT
Install the top mounting brackets using the #4 sheet
1
metal screws provided. Refer to the illustration below.
Install the lower mounting brackets using the #8 x 32
2
sheet metal screws provided, but do not tighten. The
brackets will need to be adjusted once the downdraft is
placed in the opening. Refer to the illustration below.
Top mounting bracket. Bottom leveling bracket.
TRANSITION
For internal blowers, remove the existing 254 mm round
transition. Refer to the illustration below.
For remote blowers being discharged from the front, leave
the 254 mm round transition in place.
For remote blowers being discharged from the rear, remove
the 254 mm round transition from the front and solid cover
from the rear of the downdraft, then reinstall the 254 mm
transition on the rear and solid cover on the front.
Remove transition.