Entry And Exit Delay Time - Techly I-ALARM-KIT001 Manuel D'installation

Rename RFID Tag
Send:
10
Rename RFID tag names:
1.
2.
3.
4.
Copy, paste, then edit
(case sensitive):
Rename RFID tag names:
1. Tom
2. Nurse
3. Nancy
4. David
Ok
Note
The first SMS number will receive
SMS notifications when the system
is disarmed by RFID tag. To start
receiving these notifications, you
must rename the RFID tags. Up to 4
RFID tags can be renamed. Other tags
will be attributed a number based on
the order of registration to the control
panel. Refer to the instructions on
page 8 to learn how to register an
RFID tag in the control panel.
20

Entry and Exit Delay Time

Send:
11
Entry delay time(0-300sec):0
Exit delay time(0-300sec):0
Copy, paste, then edit
(case sensitive):
Entry delay time(0-300sec):10
Exit delay time(0-300sec):20
Ok
Note
This function can be used if you do not
want to bring a remote control or a RFID
tag with you.
When you arm the system, the system
will be armed after the delay set.
When you disarm the system, the
system will be disarmed after the
delay set.
When arming the system, you hear
one beep every second to remind you
to leave. The beep rhythm speeds
up during the last 10 seconds. If an
intruder is detected, the alarm will be
delayed accordingly.