Techly I-ALARM-KIT001 Manuel D'installation page 11

Comments
This function can be used if you do not want to bring a
remote control or RFID tag with you. When the system
is armed, you hear one beep every second to remind
you to leave. The beep rhythm speeds up during the last
10 seconds. If an intruder is detected, the alarm will be
delayed accordingly.
Time is calculated in seconds. The Entry and Exit Delay can
be set from 0 to 300 seconds.
You can set up the system to arm and disarm
automatically at a defined time every day.
You can activate or deactivate the control of your system
by phone call. Activating the control by phone call enables
you to arm and disarm the system and monitor your home
by phone call.
Notification of SIM/ GSM signal problem.
Activate or deactivate the sound when typing on the
keyboard of the control panel.
Your admin code enables you to enter the setup menu.
Default admin code: 123456
Your user code enables you to disarm the system on
the control panel. The user code is the access code
requested when you call the control panel.
Default user code: 1234
In case of emergency, when you are requested to disarm
the system by force, it is recommended to disarm your
system with your Duress Code. The panel will silently
dial the stored phone numbers.
Default duress code: 1111
You can open electronic doors using this code. The door
must be wired to the [LOCK] interface on the back of the
control panel.
www.techly.com
Note
(e.g. 2014-06-20 14H30)
The entry and exit delays only
work for sensors connected as
Delay Zone accessories
"Wireless" on page 8).
The Entry Delay gives you time
to disarm the system on the
control panel without triggering
an alarm.
The Exit Delay gives you time to
arm the system on the control
panel and leave your home
without triggering an alarm.
Setting Auto Arm and Auto Disarm
to the exact same time will
deactivate the function.
See instructions on page 14 for
more information on the control
of the system by phone call.
It is recommended to change all
codes before using your system
for the first time and to keep
your codes secret
(see
11