Control By Phone Call - Techly I-ALARM-KIT001 Manuel D'installation

Zone setup of accessories
Every detector can be assigned to 4 different categories of zones: Home Zone,
Delay Zone, Normal Zone and 24-H Zone. To assign a detector to a zone, follow the
instructions on page 8 of this manual (the zone will be assigned at the time
of connection of the accessory).
Normal zone
When the system is armed, if a sensor is triggered, the siren rings out. When the
system is disarmed, sensors do not trigger an alarm.
24h zone
Regardless the system is armed or disarmed, sensors assigned to the 24h zone can
trigger an alarm. It is recommended to assign smoke detectors, gas detectors and
outdoor beam sensors to the 24-H zone.
Delay zone
If you want to set up the entry and exit delay functions, corresponding sensors
must be assigned to the Delay zone. Once the delay time has been set up, the
sensors will not trigger the alarm during the delay set. Refer to the instructions
"Entry and Exit Delay" on page 10 of this manual. It is recommended to assign
the Door / Window Contact to the Delay zone.
Home zone
When the system is armed in Home Mode, the sensors assigned to the Home zone
do not trigger an alarm. It is recommend to assign motion dectors to the Home
zone so that you can have your system armed in Home Mode when you are home
and move inside your home without triggering any alarm.

Control by phone call

This feature is available only after having enabled it from the control panel, as
explained on page 10 of this manual.
Method 1
When an alarm has been triggered, the control panel dials the stored phone
numbers. When you pick up the phone, follow the voice instructions to control the
panel from distance (refer to the instructions in the table below).
Method 2
1. Dial the telephone number of your control panel (either the number of the SIM
card in your control panel or the number of the landline to which your panel is
connected). After getting through, the voice instructions will guide you to enter
your access code.
2. Enter your user code, followed by "#".
3. A voice gives you the options you can select.
4. Select the operations to control the panel (see instructions in the table below).
14