Samsung RF24FSEDBSR Mode D'emploi page 20

in the temperature display. The temperature will
change by 1°F (or 1°C) with each press. See
below.
Fahrenheit : 37°F ➞ 36°F ➞ 35°F ➞ 34°F ➞ 44°F
➞ 43°F ➞ 42°F ➞ 41°F ➞ 40°F ➞ 39°F ➞ 38°F
➞ 37°F.
Centigrade : 3°C ➞ 2°C ➞ 1°C ➞ 7°C ➞ 6°C ➞
5°C ➞ 4°C ➞ 3°C.
The temperature control process for the Fridge
works just like the Freezer process. Press the
Fridge button to set your desired temperature.
After a few seconds, the Fridge will begin
adjusting towards the newly set temperature. This
will be refl ected in the digital display.
- The temperature of the Freezer or Fridge
may rise when you open the doors too
frequently, or if a large amount of warm
or hot food is placed inside.
- A rise in temperature may cause the digital
display to blink. Once the Freezer and
Fridge temperature return to their normal set
temperatures, the blinking will stop.
- If the blinking continues, you may need to
"reset" the Refrigerator. Try unplugging the
appliance, wait for around 10 minutes and
then plug the power cord back in.
- If there is a communication error between the
Display and Main Controller, the Convertible
Display light may blink. If the blinking continues
for a long period of time, please contact a
Samsung Electronics Service Center.
USING THE COLD WATER
DISPENSER
Push the appropriate ice type
button to select what you want
dispensed.
20_ operating
DA68-02897A(0.1).indb 20 DA68-02897A(0.1).indb 20
Using the ice lever ( 1 )
Push the Ice lever dispenser ( 1 )
gently with your glass. Ice will be
released from the dispenser.
You can choose the type of ice
by pushing the cubed or crushed
button fi rst.
Using the Water lever ( 2 )
Push the Water lever dispenser ( 2 ) gently with
your glass. Water will be released from the
dispenser.
If you push the water and Ice lever at
about the same time, the dispenser
operates only the option you actually
selected or pushed fi rst.
Please wait 1 second before removing
the cup after dispensing water to prevent
spills. Do not pull out the lever dispenser
after dispensing ice or water. It comes
back automatically.
Using the Ice & Water Dispenser
together
To get Ice and water, push the Ice lever ( 1 ) fi rst
for ice, then move your glass down and press the
water dispenser lever ( 2 ) for water.
Maintaining the Ice Bucket
• To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly it. Do
not use harsh or abrasive cleaners or solvents.
• Ice is made in cubes. When you select
"Crushed", the ice maker grinds the ice cubes
into crushed ice.
• When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
• The ice cubes generated by the rapid ice
making process will look white, which indicates
they were generated normally.
• As the ice maker in the refrigerator room
makes ice cubes even faster, move the ice
cubes from the refrigerator ice bin to the
freezer ice bin if you need more ice cubes.
• If ice doesn't come out, pull out the ice bucket
and press the test button located on the right
NO ICE NO ICE side of ice maker. See the illustration below.
Select this if you want Select this if you want
• Do not press the test button continuously
to turn ice maker off to turn ice maker off
when the tray is fi lled with ice or water. Water
may overfl ow or ice may jam the bucket.
1
2
13. 03. 13 오전 8:40 13. 03. 13 오전 8:40