Cleaning And Maintenance; Troubleshooting - Dometic ECOLINE RH 430NTE Mode D'emploi

Cleaning and maintenance

➤ Set the temperature controller (fig. 1 1, page 2) to the desired temperature
(3 – 12 °C)
➤ If you wish to switch the cooling device off, pull out the connection cable
or ...
➤ Rotate the temperature controller (fig. 1 1, page 2) anti-clockwise to the OFF
position.
8 Cleaning and maintenance
!
WARNING! Electrocution hazard
Always disconnect the device from the power supply before you clean
and service it.
A
NOTICE! Damage hazard
• Never clean the cooling device under running water or in dish water.
• Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
➤ Use a soft cloth, lukewarm water and a mild detergent to clean the inside of the
cooling device.
➤ Wash out the cooling device using clean water and dry thoroughly.
➤ At annual intervals, remove dust from the cooling aggregate at the back of the
cooling device using a brush or a soft cloth.
9

Troubleshooting

Problem
Your device is not
working (plug is
inserted).
18
Possible cause
No voltage present in the
AC voltage socket.
The inner fan or the cooling
element is defective.
The integrated mains
adapter is defective.
The main control board is
defective.
Suggested remedy
Try using another plug socket.
This can only be repaired by an
authorised repair centre.
This can only be repaired by an author-
ised customer services unit.
This can only be repaired by an
authorised repair centre.
RH430, RH440
EN