Instructions Pour L'assemblage; Nom Des Pièces - GreenWorks GPW 1802 Manuel Du Propriétaire

INSTRUCTIONS POUR L'ASSEMBLAGE

NOM DES PIÈCES
Nettoyeur haute pression
Assemblage de la gâchette
Lance de pulvérisation
Cuve à savon
Piédestal
Étui pour le pistolet
Embout turbo
Vert - Embout à petit angle (25°)
Blanc - Embout à large angle (40° )
Outil de nettoyage à pointe de pulvérisation
Vis
Manuel d'utilisation
Guide rapide de démarrage
FIGURE
WARNING: This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk Set-up
Installing the wheels Insert the axle through the wheel. of injury or death, user must read and understand operator's manual before using this product.
Slide the washer over the axle pass the pin hole. 1 Connect garden hose to pressure washer water intake.
Insert the axle and wheel through the frame. Slide the washer over the axle and insert the pin through the hole to firmly fasten
the wheel assembly.
1800 PSI / 1.1 GPM 2 Assemble pressure washer gun to spray wand.
Wheel ELECTRIC PRESSURE WASHER
GPW 1800
Put pressure washer detergent in detergent tank. USING DETERGENT 3 Connect desired pressure tip.
Axle Washer Pin Install blue or black soap nozzle.
Squeeze trigger and wait approx.1 minute for soap.
Installing the gun holder Line up the screw sleeves with the holes in the upper handle
and push through. 4
Insert the screw and turn clockwise with a Phillips head screwdriver (not included) until the screw is tight. handle. Insert high pressure hose into trigger
SPRAY TIP SPRAY TIP APPLICATION
Red - Stream tip (0° )
The red 0 degree tip provides a straight line of spray. It provides the highest 5 Connect the high pressure hose to the water outlet connector.
0 O amount of pressure. It is best used for removing hard, stuck-on grime or dirt.
Green - Narrow fan tip (25° )
Referred to as the washing tip, because it provides adequate pressure to remove The green pressure washer tip provides high versatility with its 25 degree angle tip.
25 O washer tip is designed for "sweeping" foliage or debris given its wide angle. This tip dirt from surfaces, but is designed to not damage many surfaces. This pressure 6 Turn on water at outlet.
is versatile due to its wide area of cleaning and strong pressure application.
Installing the upper handle White - Wide fan tip (40° ) The white 40 degree tip, referred to as the "fan" tip creates the widest area of
Push and hold the push-pin buttons on the sides of the upper cleaning with relatively low pressure. This pressure washer tip is best used for light or delicate cleaning applications. It is recommended for light cleaning on wood 7 Run water hose for 30 seconds with the motor in OFF position. This helps drain air
handle assembly (1) as you slide the handle onto the frame (2). 40 O decks and other soft or delicate surfaces. 30 S from the tank and lines.
(1) Black - Soap spray tip
The black soap spray tip, is used for soap application. Soap is applied under low 8 Connect power cord to wall outlet Extension cord not recommended.
Push-pin (2) SOAP pressure high volume for optimum performance. Soap cannot be applied under high pressure with this machine.
Turbo Nozzle Tip The nozzle rotates in a zero to 15 degree spray pattern in a circular motion to 9 IMPORTANT: Ensure water outlet is On Turn on Pressure Washer
break down tough dirt and grime. The spray pattern can cover area of 4 to 8 inches wide, depending on a distance between the tip and the surface being cleaned. before turning power On to avoid damage
to the pump.
NOTE:
Do Not Return to Store Missing parts, accessories or need a service center? AUTO ON/OFF SWITCH: This Pressure washer is equipped with an Auto Start/Stop feature.
Call : 1-888-909-6757 To operate: Turn the power switch to the On (I) position.
www.GreenWorksTools.com Pump will pressurize and shut down immediately. Once the trigger of the gun is depressed the unit will turn on.
Rev:02 Unit will shut off and be in standby mode when trigger is
released.
10
QTÉ
1
1
1
1
1
1
1
1
1
1
4
1
1