Hoover Nextra Mode D'emploi page 21

40003011Eng.qxd 27/04/2005
is limited to the water inlet temperature, thus reducing energy consumption
further. We recommend that the temperature shown on wash care garments
should never be exceeded.
In the case where the temperature has been accidentally set higher than that
of the chosen programme, (see Programme Guide table), the machine will
lower the temperature automatically to protect the fabrics.
Easy Iron (
This option is only available on synthetics, acrylics, woolmark and silk
programmes.
Programme
Synthetics
Acrylics
Woolmark
( )
and Silk
15:14 Page 21
)
Fast Iron Function
Programme is completed
by a short, very low spin
speed.
The machine stops in the
final rinse stage and the
option indicators blink.
The load is held in the
water in the drum, thus
reducing creasing and
enabling easier ironing.
The machine stops in the
final rinse stage and the
option indicators blink.
The load is held in the
water in the drum, thus
reducing creasing and
enabling easier ironing.
The machine stops in the
final rinse stage and the
option indicators
blink.The load is held in
the water in the drum,
thus reducing creasing
and enabling easier
ironing.
Action to complete the cycle
If a spin cycle is required please
select the appropriate spin (see
Programme Guide).
Press the button to continue
with the programme. The
machine will then pump out the
remaining water and the
programme will conclude with a
short spin. Finally, the
programme carries out a brief
tumbling action to loosen the
items in the load.
Press the button and the
machine will pump out the
water and complete the cycle
with a short spin cycle.
Press the button and the
machine will pump out the
water to complete the cycle. The
clothes load will not be spun and
will therefore be very wet.
21