40003011Eng.qxd
27/04/2005
When starting a
subsequent
wash cycle the
programme
selector must
be returned to
OFF prior to the
next
programme
being selected
and started.
18
15:14
Page 18
is shorter than 60 minutes, then the time
remaining indicator will illuminate accordingly.
The
indicator light will also illuminate a few
seconds after pressing the
Pause
The programme may be paused at any time
during the wash cycle by holding down the
button for about two seconds. When the machine
is in the paused mode, the time remaining for the
programme in the CHRONOVISION indicator and
option buttons will flash. The
will remain illuminated for approximately 2
minutes. The door can be opened when this
indicator goes out. To restart the programme,
press the
button once again.
Cancelling and changing the
programme
To cancel the programme the programme selector
should be rotated to the OFF position.
Select a new programme and start as detailed
above.
Door Locked indicator
(
)
The
indicator light is illuminated when the
door is fully closed and the machine is ON.
When
is pressed on the machine with the
door closed the indicator will flash momentarily
and then illuminate. If the door is not closed the
indicator will continue to flash.
A special safety device prevents the door from
being opened immediately after the end of the
cycle. Wait for 2 minutes after the wash cycle has
finished and the
opening the door. As a safety measure, check that
there is no water evident in the drum. At the end
of the cycle turn the programme selector to OFF.
If the programme is paused, the
will go out after 2 minutes and the door can be
opened. Check there is no water evident in the
drum before opening the door.
button.
indicator light
light has gone out before
indicator