Moving The Machine Into Position; Adjusting The Feet - Hoover Nextra Mode D'emploi

40003011Eng.qxd 27/04/2005
Option 2
Into a standpipe
Ensure that the standpipe is not located near
an electrical socket.
Fit the hooked end support to the outlet pipe.
Install the hose into the standpipe ensuring
that the pipe is at least 500mm from the floor.
Insert the outlet pipe approximately 100mm
into the standpipe.
Moving the machine
into position
Your machine is heavy so care must be taken
when moving it. We recommend that two people
move the machine to avoid strain and possible
injury.
● Take care not to damage flooring when
moving the machine.
● When moving the machine to its final
position take care not to kink or damage
the hose at the back of the machine.

Adjusting the feet

Once the machine is in place the feet should be
adjusted to ensure that the machine is level. If
the machine is not level it may become noisy or
move.
Adjust the feet on the front corners of the
machine until the machine is firm and level.
When the machine is firm and level, tighten the
locking nuts on the two feet.
15:14 Page 11
100 mm
500 mm
min
Do not drag or
lift the machine
by its door.
11