Testing The Installation - Hoover Nextra Mode D'emploi

40003011Eng.qxd 27/04/2005

Testing the installation

This
programme
will take
approximately
2 hours to
complete.
12
15:14 Page 12
Refer to the programme guide for details of how
to select programmes.
1. Turn on the water supply and check for
leaks from the fill hose.
2. Switch on the electricity supply.
3. Select the spin programme
then press the
machine. Allow the programme to continue
for one minute and then cancel the
programme by returning the selector to the
OFF position. This will remove any water
remaining in the machine from factory
testing.
4. To check for cold water filling to the
machine:
Select the rinse programme
press the
Allow the tumble action to continue until
the water has pumped out. Check that the
drain outlet is not leaking or overflowing.
5. Switch off the machine at the end of the
cycle by turning the programme knob to the
OFF position.
6. Select the spin programme
press the
the machine takes longer than one minute
to empty check the drain hose for kinks.
Installation testing is now
complete.
Now you have successfully installed the machine
we advise that you run the machine to ensure the
drum is thoroughly clean after testing and
storage. Select the
the machine for a complete cycle using only wash
detergent and water. Ensure that the drying timer
is in the OFF position.
/
button to start the
/
button to start the machine.
/
button to start the machine. If
90 programme and run
and
and
and