Hardware Info - KLEIN+HUMMEL KPA Série Mode D'emploi

The Recall local preset command loads and applies one of the stored presets, chosen through an identical dialog.
Please note that all the current amplifier settings are overwritten! Note that if you have already input a preset
name, or if you have loaded a preset from local memory or smart card, the name is kept by the amplifier and used
as starting point for a new save preset operation. For example, suppose that you have loaded a preset named
"18IN SUB 1" from a SC, and then you save it into local memory as shown in
figure 26
in asks you if you want to keep/edit that name (shown
the preset that is going to be overwritten (shown

Hardware info

In this screen you can view some information about the hardware of the amplifier:
•
S/N the serial number of the amplifier
•
HW ID the hardware identifier (always 00)
if you push the "more" button, you can view the other info
•
KFRNT the version number of the front panel
•
KCTRL the version number of the controller
•
KDSP the version number of the DSP board
•
K8 the version number K8 adapter
if you push the "more" button, you can view the other info
•
Lifetime the operating time of the amplifier
Operating Manual KPA Series
figure 27
figure 28
). This is useful for copying presets from/to smart card.
Select prese t # 3
Existing Preset
figure 25
Keep this na me?
18IN SUB 1
figure 26
Choose pre se t na me
18IN SUB 1
^
figure 27
Choose preset na me
Existing Pre
^
figure 28
English
figure 25 . In this case the menu shown
) or if you would like to edit the name of
Klein + Hummel
18