Technical Data - Pro Work PD 150 Mode D'emploi D'origine

Anleitung_PD_150_SPK7:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
2. Layout (Fig. 1)
1 ON/OFF switch
2 Safety window
3 Spark deflector
4 Safety hood
5 Grinding wheel
6 Workpiece support fastening screw
7 Workpiece support
8 Mounting holes
9 Foot
10 Spark deflector adjusting screw
3. Proper use
The double grinder is a multi-function tool for the
rough and precision grinding of metals, plastics and
other materials using a selection of grinding wheels.
The machine must only be used for its intended
purpose! Even if the machine is used as intended,
certain residual risk factors cannot be completely
eliminated. The following hazards may arise in
connection with the machineʼs construction and
layout:
Contact with the grinding wheel where it is not
covered.
Catapulting of parts from damaged grinding
wheels.
Catapulting of workpieces and parts of workpieces
from the machine.
Damage to hearing if ear-muffs are not used as
necessary.
8
19.02.2010 9:22 Uhr Seite 8
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the manufacturer
will be liable for any damage or injuries of any kind
caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

Rated voltage:
Power rating:
Idle speed n :
0
Grinding wheel diameter:
Grinding wheel thickness:
Grinding wheel hole diameter:
Max. peripheral speed:
Weight:
Load factor:
A load factor of S2 30 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (150 W) for no longer than
the time stipulated on the specifications label (30
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029-1 and EN 61029-2-4.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 61029-1 and EN 61029-2-4.
230 V ~ 50 Hz
150 W S2 30 min
2950 min -1
150 mm
16 mm
12.7 mm
23.16 m/s
6 kg
62 dB(A)
3 dB
75 dB(A)
3 dB