Water Supply Connections; Thermal Expansion - GE GeoSpring GEH50DEEJS Manuel D'utilisation

Installation Instructions
CONDENSATION DRAIN
CONNECTION
This unit has a condensate drain; therefore a floor or other
for the shortest possible drain line with minimal turns to
be installed. Drain must meet state and local codes. It is
important to install a 3
side of the unit. Diameter reductions from a
are discouraged.
downward slope to allow for proper gravity drainage of
condensate to the drain and to allow for proper function of
the condensate drain blockage sensor (see page 10). If
no drain is available, then a common condensate pump
with a capacity no less than 1 gallon (3.8L)/day must be
or rigid drain line so that the discharge water cannot
contact live electrical parts or cause water damage .
Condensate
Drain
Fitting
Additional parts needed:
fitting

THERMAL EXPANSION

If a check valve is present on the inlet water line,
closed system creates an increase in pressure within
the water system because the pressure is not able
to dissipate in the main supply line. Referred to as
can cause the relief valve to operate (releasing
water) during each heating cycle, potentially causing
premature failure to the valve or even the water
heater. The suggested method of controlling thermal
water line between the water heater and the check
valve as shown in the following illustrations. Contact
your installing contractor, water supplier, or plumbing
inspector for additional information.
14
/
4
3 /
4
Drain
Line
(Typical Installations)

WATER SUPPLY CONNECTIONS

Refer to the illustration below for suggested typical
installation. The HOT and COLD water connections are
NPT tapered thread fittings with use of thread sealant is
recommended. The installation of unions is recommended
on the hot and cold water connections so that the
water heater may be easily disconnected for servicing if
necessary.
NOTE: Install a shut-off valve in the cold water line
near the water heater. This will enable easier service or
maintenance of the unit later.
IMPORTANT: Do not apply heat to the HOT or COLD
water connections. If sweat connections are used,
sweat tubing to adapter before fitting the adapter
to the cold water connections on heater. Any heat
applied to the hot or cold water connection will
permanently damage the internal plastic lining in
these ports.
TYPICAL INSTALLATION
Conduit to Electrical
Condensate
copper conductors)
Drain
Hot water
outlet to
Fitting
Union
Drain
Line
Drain valve
Model appearance may vary
Thermal
To cold
water supply
Shut-off valve
Condensate Drain Pan
Temperature &
Pressure Relief Valve
Condensate Drain
Line
Relief Valve discharge
49-50300-2