Bosch PHO 30-82 Notice Originale page 20

20 | English
To achieve high-grade surfaces, work only with
low feed and apply pressure on the centre of the
planer base plate.
When machining hard materials (e.g. hardwood)
as well as when utilising the maximum planer
width, set only low planing depths and reduce
planer feed, as required.
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
The integrated park rest 28 also allows for con-
tinued planing at any given location on the work-
piece after an interruption:
– With the park rest folded down, place the ma-
chine on the location of the workpiece where
the planing is to be continued.
– Switch on the machine.
– Apply the supporting pressure onto the front
part of the planer base plate and slowly push
the machine forward ( ). This tilts the park
rest upward ( ) so that the rear part of the
planer base plate faces on the workpiece
again.
– Guide the machine over the surface to be
planed ( ) with even feed.
Beveling Edges (see figure H)
The V-grooves in the front planer base plate allow
quick and easy beveling of workpiece edges. De-
pending on required bevel width, use the corre-
sponding V-groove. For this, place the planer
with the V-groove onto the edge of the workpiece
and guide it along the edge.
Groove to be used Dimensio
none
small
medium
large
1 609 929 N83 | (14.1.08)
Planing with Parallel/Beveling Guide
(see figures D–F)
Mount the parallel guide 20 or beveling guide 24
to the machine using the corresponding fasten-
ing bolt 23. Depending on the application, mount
the rebating depth stop 27 with fastening bolt 26
to the machine.
Loosen the locking nut 22 and adjust the request-
ed rebating width on the scale 21. Tighten the
locking nut 22 again.
Adjust the requested rebating depth accordingly
with the rebating depth stop 27.
Carry out the planing procedure several times un-
til the requested rebating depth is reached.
Guide the planer applying sideward supporting
pressure.
Beveling with the Beveling Guide
Storage Compartment for Planer Blade/
Allen Key
A planer blade 15 and an Allen key 17 can be
housed in the storage compartment 3 as shown
in the figure. To remove the contents in the com-
partment, completely pull the storage compart-
ment for the planer blade/Allen key 3 out of the
planer.
n a (mm)
0 – 4.2
1.9 – 6.2
4.7 – 8.9
5.9 – 10.2
When beveling rebates
and surfaces, adjust the
required slope angle
with the angle adjust-
ment 25.
3
17 15
Bosch Power Tools