Bosch HDI8054UC Manuel D'installation page 18

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Measure the back left corner of the range to the bottom
of cooktop (B). Adjust leveling legsuntil this height is
the same as the corner dimension.
5. Repeat in the back right corner.
6. Use a 1¼ " wrench to adjust front leveling legs so that
the height from the bottom of the cooktop to the floor
matches the height of the corresponding countertop
surface.
English 16
Slide Range into Opening
NOTICE
To avoid risk of damage to the range oven door, do
not lift, push, or pull the range by holding the door
handle. After the door has been removed, reach
inside the top of the oven cavity to locate a ridged
area near the front of the oven. Take care not to
touch the oven heating element also located at the
top of the oven cavity, just behind the ridged area.
Note: It is recommended to wear gloves and long
sleeves to protect hands and forearms from
abrasion and potential scratches during the lifting
process. It is also recommended to take off watches
and jewelry and to wear work shoes during
installation for foot protection.
1. Remove oven door using the procedure "Removing the
Oven Door" on page 17 and lift the range off of the
packaging base.
2. Plug in the power cord.
3. Dampen countertop and floor at bottom of opening with
soapy water.
Note: Clean up any remaining soapy water
immediately after sliding the range in place.
4. Slide the range into the opening, being careful not to
damage countertops, floors, or the range door or
warming drawer front. Do not apply pressure to
cooktop when sliding into position. Be careful not to
crimp the flexible electrical connector.
5. Install the oven door using the procedure "Replacing
the Oven Door" on page 18.
Check Back of range for proper Installation
1. The cooktop should rest lightly on the countertop.
2. There should not be any gap between the countertop
and the cooktop; however, the weight of the range
must not rest on the countertop. Look under the range
to verify that both back legs are resting solidly on the
floor. Also verify that the left range leg is retained by the
anti-tip bracket.
9000989333 Rev D

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hdip054ucHgi8054ucHgip054uc

Table des Matières