Cable Lock - Zephyr ZMO-E30AS Mode D'emploi

!
CAUTION: At least two installers are
required due to the weight and size of the
hood.
tighten all the way. Note: Wood blocking may need to be
added behind the drywall if no studs are present. Wall
anchors may also be used but check local codes for
compliance. Failure to use suitable wall anchors and
screws to hold the weight of the hood could result in
personal injury or damage to cooking surface or counter.
previously removed screws.
9. Hang hood onto the mounting screws and hand tighten each
M3.5 x 8 screws.
* If using hood in recirculating mode you must secure the air diverter
to page 10 for more details.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.

Cable Lock

requirements and codes, purchase and install
appropriate connector if necessary.
11 1/4"
Brackets are
pre-installed
FIG. A
Cable Lock
3
9
17 1/2"
26" min
1
2
2
1
Motor Housing
FIG. B