Commissioning Of The Device; How To Install The Batteries - STEAMAX X-PRIV Manuel D'utilisation

STEAMAX X - PRIV – COMMISSIONING OF THE DEVICE
Operating Instructions
Fully charge the two necessary and replaceable 18650 batteries before first use. Please take note of the positive
and negative poles in the battery compartment. Ensure that there is no visible damage to the surface of the
battery cells. The device has a 510-pin connection with a spring-loaded connector, making it suitable for a variety
of sub-ohm-capable clearomizers.

How to install the Batteries

Open the battery compartment by removing the magnetically attached cover and place the two charged 18650
batteries in the device according to the marked poles. Close the battery compartment again.
Note: If the display does not light up after switching the device on, make sure that you have inserted the batteries correctly and
that they have sufficient power. If the device still cannot be switched on despite fulfilling all the aforementioned prerequisites,
please contact our customer service department
68
www.steamax.com