W-Dmx™ Status - Cameo ZENIT W600 Manuel D'utilisation

W-DMX™ STATUS
W-DMX™ W-DMX™
as receiver
deactivated
activated,
not coupled
SET DMX START ADDRESS (DMX ADDRESS)
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "DMX Address"
(observe arrow) and confirm with ENTER. The display will show a three-digit number field and you can use the UP and DOWN controls to
configure the desired DMX start address. Confirm with ENTER and press MODE to return to the main display (in the example, "DMX address
001").
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
SET DMX MODE (DMX Mode)
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "DMX Mode" (observe
arrow) and confirm with ENTER. In the sub-menu you can use UP and DOWN to choose between the following DMX modes: "15CH", "10CH",
"8CH 2", "8CH 1", "4CH", "3CH" and "2CH". Confirm your selection with ENTER. DMX tables with the channel assignments can be found in
these instructions under DMX CONTROL.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
W-DMX™ W-DMX
as receiver activated and
activated and coupled device,
device coupled, no DMX signal
Transmitter off,
or out of range
001
-
DMX address
5xx
001
------------ DMX MODE ------------
15CH
10CH
8CH 2
8CH 1
4CH
3CH
2CH
W-DMX™ W-DMX™
as reveicer and transmissi-
activated and on mode G3
coupled device, Arrow up = send
DMX signal is operation
present Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
Coupled
G3 G4S
W-DMX™
and transmissi-
on mode G4S
Arrow up = send
operation
Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
coupled
7