Technical Data - Cameo ZENIT W600 Manuel D'utilisation

DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect the shielding of the cable to the ground
contact of the plug, and always make certain that the shielding does not come into contact with the housing of the XLR plug. If the shielding
is connected to the ground, this can lead to short-circuiting and system malfunctions.
Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.

TECHNICAL DATA

Model name:
Product type:
Type:
Colour spectrum LED:
No. of LEDs:
LED type:
LED PWM frequency:
Beam angle:
DMX input:
DMX output:
DMX mode:
DMX functions:
Standalone functions:
Control:
Operating controls:
Display elements:
Operating voltage:
Power consumption:
14
1
3
2
CLZW600
LED wash light
Outdoor spotlight
RGBW
40
15 W CREE
800 Hz, 1200 Hz, 2000 Hz, 3600 Hz, 12 kHz, 25 kHz (adjustable)
18° (35° field)
5-pin XLR male, IP65
5-pin XLR female, IP65
2-channel, 3-channel, 4-channel, 8-channel 1, 8-channel 2, 10-channel, 15-channel
dimmer, dimmer fine, RGBW, RGBW fine, stroboscope, dimmer curves, colour temperature correction,
dimmer response, colour macros, colour change, colour fading, LED refresh rate
colour mixing, colour macros, master/slave mode, auto modes, stroboscope, dimmer response, dimmer
curves, display lock function, colour calibration, LED refresh rate
DMX512, W-DMX™, RDM enabled
mode, enter, up, down
OLED display
100–240 V AC/50–60 Hz
565 W
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
3 3
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
4
2
1