Panasonic DG-DV2500E Mode D'emploi page 63

Warning display (Displayed regardless of the DISPLAY mode)
When a warning display appears, this unit stops operation and cease to accept any opera-
tion commands. When TAPE DEFFECTIVE (5605 - 5609) is displayed, the unit similarly
stops operation but accepts one command, viz EJECT.
Display
CONDENSATION
ON DRUM
WARNING 3200
LOADING FAILURE
WARNING 3300
UNLOADING FAILURE
WARNING 4100
CASSETTE
EJECT FAILURE
DEFECTIVE TAPE!
5605 - 5609
WARNING 5702
TAPE END DET.
ERROR!
WARNING 5802
TAPE BEGIN
DET. ERROR!
WARNING 7001
DRUM MOTOR
FAILURE
WARNING 7101
CAP MOTOR
FAILURE
WARNING7202 -
7203
SUPPLY REEL
FAILURE
WARNING7302 -
7303
TAKE UP REEL
FAILURE
WARNING7305
TAKE UP REEL
FAILURE
WARNING 7401
REEL MOTOR
FAILURE
UNPLUG MAIN
POWER, PLUG
BACK IN AFTER A
WHILE
Memo
This unit uses a microcomputer. It may not function correctly if there is external noise. If this hap-
pens, please turn off the power and then on again.
Status
Condensation.
Unable to load tape.
Unable to eject tape.
Eject error.
Tape is cut.
Tape ending sensor error.
Tape begin sensor error.
Drum rotation error.
Capstan rotation error.
Supply reel rotation error.
Take up reel rotation error.
Tape winding error during unload-
ing.
Reel motor rotation error.
This is a system error that occurs
when the power is turned on. The
POWER indicator on this unit blinks
in green. The unit will not accept any
operation commands.
Action
Please leave the power on and wait for the
display to disappear.
This error can be resolved by restarting
the unit. However, doing so may damage
the tape in some cases. Please consult
your PANASONIC authorized dealer.
Press the EJECT button and retrieve the
cassette.
Then replace the tape.
This error can be resolved by restarting
the unit. However, doing so may damage
the tape in some cases. Please consult
your PANASONIC authorized dealer.
Unplug the mains cable from the power
outlet and wait for some time before plug-
ging it back in.
E-63