Transcend EZEX Mode D'emploi page 11

CLEANING AND REPLACING THE FILTER MEDIA
The Transcend EZEX Filter Media should be replaced
every six months. Contact your homecare dealer to
purchase a replacement Filter Media.
1. Remove the filter frame by gently pressing the button
release and lifting the plate away from the CPAP
(Image 1).
2. Remove the Filter Media from the filter frame and
discard.
3. Insert a new Filter Media into the filter frame (Image
2).
4. To replace the new filter frame, lay it on the bottom of
the CPAP. Snap the front clips into place first, then
snap the connector into place.
The Filter Media should be removed and cleaned
weekly.
1. To clean the Filter Media, first submerge a lint-
free cotton cloth into the cleaning solution*.
2. Wring excess water from the cloth.
3. Gently pat the Filter Media with the cloth.
4. Dry surfaces by wiping with a dry, lint-free cotton cloth.
5. Allow the Filter Media to air dry at room temperature for approximately 30-60 minutes before
reassembly. Drying time will depend on ambient conditions.
6. Reconnect the Filter Media and filter frame to the Transcend EZEX.
* A solution of 5% mild liquid detergent in distilled water (1.6 fl oz liquid detergent per quart of
distilled water) is recommended.
TRANSCEND EZEX QUICK GUIDE
1
2
• ENGLISH • PAGE 11