Dimensions; Eyewash Installation - Bradley S19-788H Mode D'emploi

Installation

Dimensions

44¼"
(1124mm)
1 Eyewash installation — S19-788H
Remove the plastic dust plug from the bottom of the yoke
assembly and discard.
B
Attach the pressure gauge to the adapter
on the pressure side of the tank with
pipe sealant (by installer).
NOTICE: When attaching the pressure
gauge to the tank inlet, hold the
adapter (item 3) with a wrench to
prevent stripping. Failure to do so
may damage the seal and cause
leakage. Max. torque 150 in-lbs.
Bradley Corporation • 215-1416 Rev. P; ECN 12-05-001C
34¼"
(870mm)
14"
(356mm)
6"
(152mm)
37⁵⁄₈"
(956mm)
Attach the eyewash yoke assembly to the
tank. Max. torque 150 In-Lbs. Route the
A
cable through the tank handle.
NOTICE: Check to ensure the heat trace
cable from the yoke assembly is not
kinked or damaged from assembly.
4/3/2012
S19-788H
3