Installation
Dimensions
37⁵⁄₈"
(956mm)
1
Eyewash installation — S19-690H
Remove the plastic dust plug from the bottom of the yoke
assembly and discard.
B
Attach the pressure gauge to the adapter
on the pressure side of the tank with
pipe sealant (by installer).
NOTICE: When attaching the pressure
gauge to the tank inlet, hold the
adapter (item 3) with a wrench to
prevent stripping. Failure to do so
may damage the seal and cause
leakage. Max. torque 150 in-lbs.
Bradley Corporation • 215-084 Rev. W; ECN 12-05-001C
24⁵⁄₈"
(625mm)
14"
(356mm)
(152mm)
27¾"
(705mm)
Attach the eyewash yoke assembly to the
tank. Max. torque 150 In-Lbs. Route the
A
cable through the tank handle.
NOTICE: Check to ensure the heat trace
cable from the yoke assembly is not
kinked or damaged from assembly.
4/3/2012
S19-690H
6"
3