Settings - Bodet HARMONYS Flash Notice D'installation Et D'utilisation

3.3 Settings

This page can be used to configure the operational settings of the device as follows:
- Multicast (Address A and B): multicast address for sending ring commands (no schedule sent) (by default:
- Brightness: Adjust the brightness to 4 levels (25%, 50%, 75% and 100%) depending on where the product is
installed (strongly or weakly sunny ...).
- Zone no.: enables definition of the number of the zone in which the product is located.
- Client repeater/server (tick box): in the case of a complex network installation with one or more remote sites, it may
- Repeater address: can be used to enter the network address of the other Flash in the repeater pair.
The buttons Save and Save and Reboot can be used to save data changes in the concerned device, and then restart it.
8
A=239.192.55.1, B= not specified).
be necessary to set up network gateways. To do so, it will be necessary to define
repeaters which will pass the information from one network to the other. For each
pair, one Flash is defined as the server and the other as the client. It is advisable,
although not compulsory, to place the server repeaters in the network where the
Sigma is located (and the microphone).
EN