Installation - Bodet HARMONYS Flash Notice D'installation Et D'utilisation

2. INSTALLATION

Choose the location where the Harmonys Flash is to be installed according to the present of Ethernet cable.
Open the case of the Harmonys Flash using a flat-blade screwdriver.
1- Position the screwdriver in the space provided, located underneath the product (1).
2- Remove the cover using the tip of the screwdriver as a lever to separate the cover from the mounting plate (2).
Use the scewdriver as a lever to pry the cover open but do not push the
blade more than 1 cm inside the casing so that the blade is resting on the
back casing, not on the pc board.
3- Remove the front cover carefully.
4- Attach the Harmonys Flash using the 3 mounting screws provided
5- Make sure that the Harmonys Flash is resting well on the wall.
6- Connect the RJ45 Ethernet cable and clip the front panel
Light sequences
> Normal mode:
Green flash (200 ms) - White flash (200 ms) - Green flash (900 ms) - White flash (200 ms)
Length: 10 seconds.
> Alert mode:
Red flash (250 ms) - White flash (250 ms) - ...
Length: repeated for the entire duration of the alarm
> Localisation mode (Sigma software):
White flash (500 ms) - off (500 ms) - ...
Length: repeated for the entire duration of localisation
> Test mode (pressing the test button):
White flash (500 ms) - Red flash (500 ms) - Green flash (500 ms)
Length: cycle executed once
> Repeater error mode:
Red flash cycle.
1
RJ45 Ethernet connector
2
Back casing - Rear view
On: power OK
Off: no power.
Green (fast flashing):
network search.
Green (slow flashing):
connected to the network
Red (slow flashing): loss or
failure of network connection
EN
70
130
44
Zone of the light
sequences
5