PRASTEL TC1000 Manuel D'installation page 13

7. Selectable functions through dip-switch
It is important to change the configuration of the dip-switch only when the unit is
turned off!!! Turn off the power supply during the change of configuration.
Default settings
The control board is supplied with the dip-switches set as indicated in the Pict. 1. In the table are sum up the functions that can be selected through
these dip-switches.
Fig.1: impostazione di
fabbrica dei dip
7.1 Functioning on opening/closing
This function enables to select the method of opening/closing of the automation.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
The operating mode with "pulse function" activated can be selected by the dip 4.
6-1622609 rev.2 03/08/2015
dip
1 Function on opening
2 Function on closing
3
4 Pulse functioning
The automation operates under dead man mode on opening.
The automation operates under pulse mode on opening.
The automation operates under dead man under on closing.
The automation operates under pulse mode on closing.
ITA
Function
Working time
Dip-switch function table
ENG FRA ESP DEU POR
Dip OFF
Dead man Impulse on opening
Dead man Impulse on closing
Programmable
Open— close Step by step functionGO)
}
Wired or
Remote control
}
Wired or
Remote control
Dip ON
Infinite
5 / 8