PRASTEL TC1000 Manuel D'installation page 10

Programmable control unit for metallic rolling shutters and sectional doors
PRASTEL'S TRANSMITTER COMPATIBLE: SLIMXE, TCXE, MPSTLXE, MPSTF3E
1. Introduction
The control unit TC1000 is a control unit developed to control rolling shutters in an easy and intuitive way. This product controls motors up to 230 Vac
up to 1000W. It is equipped with a courtesy light output. The product is compliant with transmitters with 2 or 3 buttons. It is equipped with a photocells
output.
WARNING : DO NOT INSTALL THE CONTROL UNIT WITHOUT READING THE INSTRUCTIONS FIRST !!!
2. Setting
Signalling
led
3. Electrical connections
The control unit is supplied with all the inputs normally closed and jumpered to the common.
Before connecting a device to the control unit remove the jumper corresponding to the device that you want to
connect leaving the others unchanged.
1
2
6-1622609 rev.2 03/08/2015
Control unit TC1000
Connect the power supply cable between the
clamps 10 and 11 of the control unit.
Connect an eventual courtesy light between
the clamps 12 and 13 of the control unit.
ITA ENG FRA
Power supply 230 Vac 50Hz
Do not connect the card directly to the electric
network. Put a device which can ensure the
disconnection of each pole from the power supply of
the control unit.
Connecting a charge of 230Vac 500W MAX it is
possible to light up the operating zone of the
automation during each motion. The turning off is
timed with a period of 3 minutes. The counting is
reset at each impulse of up or down.
ESP DEU POR
2 / 8