PRASTEL TC1000 Manuel D'installation page 12

6. Learnings
6.1 Learning a transmitter through the "RADIO LEARN" key of the control unit
Warning: the key function is assigned in the order of learning:
st
1 learnt button:
"UP"
6.1.1 Learning of a two buttons transmitter
STOP THE
AUTOMATION
Press and release the UP button of the transmitter. The
buzzer emits two long beep. The button is learnt and the
procedure finishes with two short beep.
Press and release the RADIO LEARN button. The buzzer
emits long beeps each second.
Press and release the DOWN button of the transmitter. The
buzzer emits a long beep. The button is learnt and the
procedure finishes with two short beep.
6.1.2 Learning of a three buttons transmitter
STOP THE
AUTOMATION
Press and release the UP button of the transmitter. The
buzzer emits two long beep. The button is learnt and the
procedure finishes with two short beep.
Press and release the RADIO LEARN button. The buzzer
emits long beeps each second.
Press and release the DOWN button of the transmitter. The
buzzer emits a long beep. The button is learnt and the
procedure finishes with two short beep.
Press and release the RADIO LEARN button. The buzzer
emits long beeps each second.
Press and release the DOWN button of the transmitter. The
buzzer emits a long beep. The button is learnt and the
procedure finishes with two short beep.
6-1622609 rev.2 03/08/2015
nd
2 learnt button:
"DOWN"
Press and release the RADIO LEARN
button. The buzzer emits long beeps each
second.
YES
YES
YES
Press and release the RADIO LEARN
button. The buzzer emits long beeps each
second.
YES
YES
YES
YES
YES
ITA ENG
st
1 learnt button:
"UP"
Check that the automation is still.
NO
If the buzzer emits a long beep, the transmitter has
already been memorized. If the buzzer does not make
NO
any signal verify that the transmitter works.
Check that the automation is still.
NO
If the buzzer does not make any signal verify that the
NO
transmitter works.
Check that the automation is still.
NO
If the buzzer emits a long beep, the transmitter has
already been memorized. If the buzzer does not make
NO
any signal verify that the transmitter works.
Check that the automation is still.
NO
If the buzzer does not make any signal verify that the
NO
transmitter works.
Check that the automation is still.
NO
If the buzzer does not make any signal verify that the
NO
transmitter works.
FRA ESP DEU POR
nd rd
2 learnt button: 3
"DOWN"
learnt button:
"STOP"
4 / 8