Bresser Temeo io Mode D'emploi page 22

display mode. Press SET button again to confirm and
exit setting.
Alarm setting
1. Press and hold the ALARM button in normal display mode
for 2 seconds to enter into alarm time setting mode.
2. The figure to be set will start flashing.
3. Press the DOWN or UP button to change this setting.
4. Press the ALARM button to confirm and go to the
next setting.
5. The setting order is hour >> minute >> save and exit.
6. Press ALARM again to confirm and exit setting mode.
7. Press SET button to turn on or off the alarm, When the
alarm is activated, the icon
When this alarm bell symbol is not displayed the alarm
is off.
8. The alarm sounds for a total of 2 minutes and will
change characteristics along that time.
Sensor function
1. Press °C/°F to change the temperature display of the
transmitter
3. Once the weather station receives radio signals from
the sensor, the temperature value will be updated on
the base unit every 1-2 minutes.
TROUBLESHOOTING
Signal disconnection
If without obvious reasons the display of the outdoor
temperature goes blank, please check the following:
22
is showed on the screen.