Bresser Temeo io Mode D'emploi page 21

1. Press and hold MIN/MAX/+ button for 2-3 sec to
re-start receiving from the transmitter; the data will
normally be received within 3 minutes.
2. If the first step does not yield a desirable solution,
please remove the batteries and re-install them
(hardware reset).
At the same time, please make sure the following:
1. The main unit as well the as transmitter should be at least
5~6.5 feet (1.5~2 meters) away from any interfering
sources, such as computer monitors or TV sets.
2. The main unit should not stand close to metal window
frames.
3. Please do not using other electrical products, such
as headphones or speakers, operating on the same
signal frequency (433.92 MHz).
4. Electrical devices operating on the same signal
frequency may also cause interference. This can
include devices used in the neighborhood as well.
Manual time setting
1. Press and hold the SET/°F/°C button in normal
display mode for 2 seconds to enter into time setting
mode.
2. The figure to be set will start flashing.
3. Press MIN/MAX/+ button to change the value.
4. Press SET button to confirm and go to the next value
to be changed.
5. The setting order is 12/24hr >> hours >> minutes >>
save and exit.
6. If there is no operation for 30 seconds, the existing
setting will be saved and the device returns to normal
DE
GB
FR
IT
ES
21