• Wipe the appliance's exterior surface, control panel and carafe plate with
a soft damp cloth. Do not use abrasive cleansers or scouring pads. Never
immerse the coffeemaker in water.
• To clean the inside of the cover, open the cover and leave in the open
position. Wipe surfaces with a damp cloth.
AUTO CLEAN
De-scaling With Auto Clean™
Over time, calcium deposits or "scale" may build up in your brewer. Scale is
non-toxic but if left unattended will hinder brewer performance. Regularly
de-scaling your brewer helps to maintain quality coffee as well as the
lifespan of the heating element, and other internal parts that come in
contact with water throughout the brew process.
To make the de-scaling process as effortless as possible, an Auto Clean™
system has been programmed into your coffeemaker.
When should I use Auto Clean™?
You should clean your coffeemaker after every 60 brews (approximately 2
months). If you would like to clean your coffeemaker prior to 60 brew cycles
because of hard water, you may do so.
How do I use Auto Clean™?
Follow the simple steps below. Your coffeemaker will take care of the rest.
1.
Combine 6 cups of white vinegar and 4 cups of cold water in carafe.
2.
Pour into water reservoir.
3.
Press and Hold the On/Off button for 3 seconds
4.
On/Off Button LED illuminates (no blinking)
5.
"CL" appears in the display, blinking once per second and the Auto-
Clean cycle begins.
During the Auto-Clean Cycle Function:
1.
Machine will brew approximately 5 cups of cleaning solution
2.
Part of the mixture will brew through. Remaining mixture will be held in
coffeemaker for 30 minutes before completing its brew through.
3.
Machine will continue brewing remainder of cleaning solution
Note: The entire cleaning cycle will take 45–60 minutes to complete.
4.
When the coffeemaker completes the AUTO CLEAN cycle, it shuts off
automatically.
5.
Brew fresh water through appliance following instructions given in
GETTING STARTED before brewing coffee again.
SYSTEM
®
9