Black & Decker MTD100 Manuel D'instructions page 3

20V MAX* lithiuM tRiMMER / EDGER
iNStRuCtiON MANuAl
Model Number lSt220
thank you for choosing Black & Decker! Go
to www.BlackandDecker.com/NewOwner
to register your new product.
PlEASE READ BEFORE REtuRNiNG
thiS PRODuCt FOR ANY REASON:
If you have a question or experience a problem with your
Black & Decker purchase, go to
WWW.BlACKANDDECKER.COM/iNStANtANSWERS
for instant answers 24 hours a day.
If you can't find the answer or do not have access to the internet,
call 1-800-544-6986 from 8 a.m. to 5 p.m. EST Mon. - Fri
to speak with an agent.
Please have the catalog number available when you call.
SAVE thiS MANuAl FOR FutuRE REFERENCE.
VEA El ESPAÑOl EN lA CONtRAPORtADA.
POuR lE FRANÇAiS, VOiR lA COuVERtuRE ARRiÈRE.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO
Y PÓLIZA DE GARANTÍA. ADVERTENCIA: LÉASE ESTE
INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
Model # lSt220
KEY iNFORMAtiON YOu ShOulD KNOW:
• The guard must be installed before trimming or edging - if
not, the motor will overheat (page 8).
• When replacing the line, use only .065 inch diameter
ROUND line (B&D Model #AF-100 is recommended) -
otherwise the tool will not function properly (page 10).
• Do not bump the feed head against the ground - it will
disrupt the feed mechanism.
1
*Maximum initial battery pack voltage
(measured without a workload) is 20
volts. Measured under a workload,
nominal voltage is 18.