dirna Bergstrom bycool blue line FLAT 24V Instructions De Montage page 25

FLAT
Fasten the fastening supports by tightening
12
the nut until the outer EPDM seal tightening
of the equipment is between 3 and 6mm.
Important: To avoid possible water leaks
into the inside of the cab the EPDM seal
tightening must be adjusted with the base of
the Bycool as indicated in the drawing.
3-6mm.
Cab roof
Tighten the nuts until the
seal tightening of the rubber
12
is between 3 and 6 mm.
Screw (4) M8 nuts to the support and (4) to
13
the base of the Bycool.
EPDM gasket
10 mm*
(*) (approx. after tightening)
Air conditioning for vehicles
Base
Support
25
Check compression
thickness using a
tape
measure in the four
corners.
EPDM gasket
ES
EN
12
13