Operations - Televes 7167 Manuel D'instructions

Operations

1.- Turn ON the Transmitter (TX) and Receiver (RX) power
2.- Power ON the A/V sources and A/V display.
3.- Adjust the A/V Channel by combining the back switches.
Switch the Channel selector of Transmitter (TX) and Receiver (RX)
to the same channel.
4.- IR Extender.
Make sure the IR Extender mouse put in front of the A/V source's IR Sensor.
5.- A/V Loop Through Connection.
If you want to watch the program from the A/V source at the room of Transmitter (TX)
located, you just need to connect the Transmitter (TX) to TV display by the SCART cable
(FEMALE side)
The product designed in loop through connection enables an audio video to be looped
through various devices without using external splitters. As diagram shown below, A/V
sources 1 can transmit audio video signals to both Transmitter (TX) and A/V Display at the
same time, you and your family will concurrently enjoy the program either in living room or
in dining room.
MALE side for
A/V source
ON
POWER
OFF/ON
1 2 3
ID/CH SET
DC 9V
A/V Sources
FEMALE side
for A/V display
CH1 On
CH2 On
CH3 On
CH4 On
CH5 Off
A/V channel
CH6 Off
ON CH7 Off
R
N
1 2 3
CH8 Off
ID/CH SET
ON
POWER
OFF/ON
1 2 3
ID/CH SET
DC 9V
Loop through
1 2 3
On On
On Off
Off On
Off Off
On On
On Off
Off On
Off Off
Transmitter
A/V Display
Transmitter
33
EN