Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CPU & Cooler Installation
When you are installing the CPU, make sure the CPU has a cooler attached on the top
to prevent overheating. Meanwhile, do not forget to apply some thermal paste on CPU
before installing the heat sink/cooler fan for better heat dispersion.
Follow the steps below to install the CPU & cooler correctly. Wrong installation will
cause the damage of your CPU & mainboard.
1.
Open the load lever.
3.
After confirming the CPU direction for
correct mating, put down the CPU in
the socket housing frame. Be sure to
grasp on the edge of the CPU base.
Note that the alignment keys are
matched.
Important
Visually inspect if the CPU is seated well into the socket. If not, take out the CPU with
pure vertical motion and reinstall.
Alignment Key
2.
Lift the load lever up to fully open
position.
4.
Remove the plastic cap. Engage the
load lever while pressing down lightly
onto the load plate.
En-7
Publicité
Table des Matières
