Installer Section; Installation; Unpacking And Preparing The Appliance For Use; Electric Connection - Gastrodomus TSB Manuel D'installation

UK

INSTALLER SECTION

Dimensions (mm)
Power supply
Frequency
Blender/Mixer RPM
Absorbed power
(W att)
page 14
1.

INSTALLATION

1.1 Unpacking and preparing the aplliance for use
• Unpack the appliance and remove the packing material.
• Place the appliance on a surface which is not slippery.
1.2 Connection to the mains
The connection to the electric supply have to be made by a
magnetothermic omnipolar switch, with distance of 3 mm between
the contacts, or by fuses, or by a differential properly sized
according to the electric norms in force.
This switch have to be dedicated only to this use and installed close
to the aplliance.
Please make sure that there is a proper ground connection.
N.B. The connection
characteristics. it
must be at least of the H05 RN F type and have a section suitable
for the aplliance power.
N.B.: The appliance is equipped with a 220-240 Vac 50
Hz connection.
2.

TECHNICAL DATA

SPECIFICATIONS
180
590
cable must
MULTIPURPOSE UNIT
I. ICE CRUSHER
II. JUICER
III. BLENDER
590x180x540
220-240 Vac
50 Hz
(1°) 13000 - (2°) 19000
900
540
have the following
MULTIPURPOSE UNIT
I. ICE CRUSHER
II. JUICER
III. BLENDER
IV. MIXER
590x325x540
220-240 Vac
50 Hz
(1°) 13000 - (2°) 19000
(Mixer) 15000
1050
325
590
540