STOK Island SGP2220SB Manuel D'utilisation page 18

STEP 19: TESTING VALVES, HOSE, AND REGU-
LATOR FOR LEAKS
See Figure 26.
Connections on the hose and regulator were tested at the
factory to ensure no gas leaks were present. However, ship-
ping and handling could loosen connections. As a safety
precaution:
 Turn all control knobs on the control panel off.
 Make sure the regulator is properly connected to the LP
gas cylinder.
 To open the cylinder valve: turn handwheel counterclock-
wise.
If you hear a rushing sound, immediately turn off the
cylinder valve. This sound means there is a major leak at
the connection. Correct the problem before proceeding.
 Using a clean paint brush and a 50/50 mixture of mild
soap and water, brush soapy solution over all the con-
nections and fittings on the grill.
 "Growing" bubbles indicate a leak. Close the cylinder
valve then retighten all connections.
NOTE: If leaks cannot be stopped, do not try to repair.
Call for replacement parts.
 If you are not using the grill immediately after the leak test,
close the cylinder valve by turning the valve clockwise).
STEP 20: TESTING THE LP GAS CYLINDER
See Figure 27.
 Turn the control knobs on the control panel off, turn off
the LP gas cylinder valve, and disconnect the regulator
from the cylinder.
 Remove the LP gas cylinder from inside the cabinet.
 Using a clean paint brush and a 50/50 mixture of mild
soap and water, brush soapy solution over areas indicated
by arrows in figure 24.
 "Growing" bubbles indicate a leak. Do not use or
move the gas cylinder. Contact a gas supplier or the fire
department!
 If you see, smell, or hear the hiss of escaping gas from
the liquid propane cylinder:
• Move away from liquid propane cylinder
• Do not attempt to correct the problem yourself
• Call your local fire department
ASSEMBLY
HOSE
Fig. 26
Fig. 27
18
REGULATOR
LP GAS CYLINDER
WITH "GROWING"
BUBBLES