RIDGID SeeSnak LT1000 Mode D'emploi page 10

SeeSnake
7. Insert the four screws through the mounting bracket
and side plate into their individual nuts and hand
tighten.
Figure 11 – Near Side-Plate Mounted
8. Repeat the process with the other side plate and
mounting bracket. The two side plates should be
level.
9. Route the SeeSnake System Cable from the See-
Snake between the side plates and connect it to the
SeeSnake Connector on the bottom of the right-
hand platform. The SeeSnake System Cable has a
guide ridge molded into the top of the cable con-
nector. With the guide ridge aligned with the guide pin
of the receptacle, insert the System Cable into the
System Connector firmly and turn the locking sleeve
clockwise to tighten it in position.
Locking Sleeve
Guide Ridge
Figure 12 – Attaching the SeeSnake System Cable
When connecting/disconnecting the SeeSnake
NOTICE
system cable, turn only the locking sleeve. To prevent
damage, do not bend or twist the connector or cable.
8
® LT1000
USB Connector
Ridge Tool Company
Figure 13 – Mounting Right-Hand Platform
10. Mount the right hand (keyboard) platform by aligning
it with the mounting holes in the flanges of the side
plates and screw it hand tight with four screws. Adjust
the platform so it is level.
Pin
Hole
Figure 14 – Alignment Pin and Hole
A small alignment pin at each end of each platform should
fit into a matching hole to seat the platform side fully.
11. Locate the left hand laptop platform, which is the
one without the keyboard. Align it to the four holes (in
the flanges of the side plates) and insert the four
screws and hand-tighten them.
Figure 15 – Mounting the Left-Hand Platform