Cleaning And Care - oneConcept 10029282 Mode D'emploi

• Cut off power source and let the coffee maker cool down completely before cleaning.
• Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip
tray and removable shelf regularly then dry them.
• Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for cleaning.
• Detach the metal funnel through turn it anticlockwise, get rid of coffee residue inside, then
you can clean it with cleanser, but at last you must rinse with clear water.
Cleaning Mineral Deposits
1. To make sure your coffee maker operating efficiently, internal piping is cleanly and the
peak flavor of coffee, you should clean away the mineral deposits left every 2-3 months.
2. Fill the tank with water and descaler to the MAX level (the scale of water and descaler is
4:1; the detail refers to the instruction of descaler. Please use "household descaler", you
can use the citric acid (obtainable from chemist's or drug stores) instead of the descaler
(the one hundred parts of water and three parts of citric acid).
3. According to the program of pre-heating, put the metal funnel (no coffee powder in it)
and carafe (jug) in place. Brewing water per "PRE-HEATING".
4. Press the ON/OFF switch to "1" position, the red lamp will be illuminated, press the
steam switch to the "0" position and the coffee/hot water selector to the "1" position,
when there is water flowing out and close the pump the coffee/hot water selector to the
"0" position, and waiting for a moment, the coffee maker begins to be heated.
5. When the green lamp is illuminated, it shows the heating is finish. Pressing the coffee/
hot water selector to the "1" position and make make two cups coffee (about 2Oz). Then
close the pump the coffee/hot water selector to the "0" position and wait for 5s.
6. Press the steam switch to the "1" position, waiting for until the green indicator is illumi-
nated. Make steam for 2min, then turn the steam control knob to "OFF" or "0" position
to stop making steam. Press the steam switch to the "0" position to stop the unit imme-
diately; make the descalers deposit in the unit at least 15 minutes.
7. Restart the unit and repeat the steps of 4 6 at least 3 times.
8. Then Press the ON/OFF switch to "1" position, when the green lamp is illuminated, press
the coffee/hot water selector to the "1" position to brew until no descaler is left.
9. Then brewing coffee (no coffee powder) with tap water in the MAX level, repeat the
steps of 4 6 for 3 times (it is not necessary to wait for 15 minutes in step of 6), then
brewing until no water is left in the tank.
10. Repeat the step of 9 at least 3 times to make sure the piping is cleanly.
12

Cleaning and Care