Use And Operation - oneConcept 10029282 Mode D'emploi

Use and Operation

Before first Use
Pour water into water tank, the water level should not exceed the "MAX" mark in the tank.
Then replace the water tank cover. Note: The appliance is supplied with a detachable tank
for easy cleaning, you can fill the tank with water firstly, and then put the tank into the
appliance.
Connect to power source, turn the ON/OFF switch(you
should buck-up the left knob if the indicator lamp is not illu-
minated), open the steam knob, the pump begins to work
and th water will come out, then buck-up the steam knob.
Note:
There may be noise when pump the water it is normal
The switch indicator lamp begins to twinkle when the coffee maker is preheating, the pre-
heating finished time is about two minutes and the indicator lamps twinkle will be stopped
and lighted status.
Press one cup switch to let the hot water clean coffee rosebox or coffee
cup. Began to boil the coffee/engine condition.
Note: The appliance is not equipped with jug, please use yourself jug
or coffee cup.
Machine is at the same time in the preheating, grinding well a good coffee
powder(coffee powder need 1 which can't be too thick nor too thin) packed into
the metal strainer mesh and then use pressure pressed powder compaction.
At the same time will be on the edge of the funnel coffee powder with a
brush or hand wipe clean (if need to make 1 cup, with a cup of the nets, if
need to make 2 cups with 2 cups).
Select 1 cup, coffee begins to flow 1
cup of coffee. (or select 2 cups, then
it is out 2 cups of coffee).
At the same time, adjust the position
of the coffee cup make coffee liquid
along the glass into the cup 10.Wait
a moment let coffee drip off, coffee
finished!
10