Thermador HMWN30 Manuel D'installation page 11

Wiring the HOOD with an
Integral Ventilator:
Warning: Turn off electricity at
the service panel before wiring the
unit.
1. Connect the Integral Ventilator
m o l e x p l u g c o n n e c t o r t o t h e
connector present inside the
hood as shown in Figure 6.
2. R e m o v e t h e j - b o x c o v e r a s
shown in Figure 7.
3. Remove 1 of 2 knockouts and
install 1/2" conduit connector
in j-box.
4. R u n b l a c k , w h i t e , a n d g r e e n
wires (#14 AWG) in 1/2"conduit
from power supply to j-box.
5. Connect black, white, and
green wires from power supply
to black, white, and green/
yellow wires in j-box
respectively.
6. Close j-box coover.
7. Turn power on at service panel.
Check operation of the hood.
Power supply conduit
Figure 7
Motor Connector
Figure 6
11